You are here :Home > Exam News > Released 300-410 ENARSI Training Questions

Released 300-410 ENARSI Training Questions

By Examgood | March 19,2020 01:53 AM

Implementing Cisco Enterprise Advanced Routing and Services 300-410 ENARSI training questions have been released, which contain 76 Q&As. The Implementing Cisco Enterprise Advanced Routing and Services v1.0 ENARSI 300-410 exam is a 90-minute exam associated with the CCNP Enterprise and Cisco Certified Specialist-Enterprise Advanced Infrastructure Implementation certifications.

Cisco 300-410 ENARSI Basic Information

Cisco 300-410 ENARSI exam certifies your knowledge for implementation and troubleshooting of advanced routing technologies and services including Layer 3, VPN services, infrastructure security, infrastructure services, and infrastructure automation. Cisco certification 300-410 ENARSI exam languages are English and Japanese. You can register Cisco 300-410 ENARSI exam at Pearson VUE test center.

Note: Due to the effect of COVID-19, some test centers are limited or closed. Please check the details on Pearson VUE coronavirus update page.

Cisco 300-410 ENARSI Exam Topics

Cisco certification 300-410 ENARSI exam topics cover the following sections.

300-410 ENARSI Training Questions

The new released 300-410 ENARSI training questions are the best material for you to study the test. Share some sample questions of Cisco 300-410 ENARSI training questions below.

1.Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

A. Router ospf3 1 address-family ipv4

B. Router(config-router)#ospfv3 1 ipv4 area 0

C. Router(config-router)#ospfv3 3 1

D. Router ospfv3 1 address-family ipv4 unicast

Answer: A

2.What is a prerequisite for configuring BFD?

A. All routers in the path between two BFD endpoints must have BFD enabled.

B. Jumbo frame support must be configured on the router that is using BFD.

C. Cisco Express Forwarding must be enabled on all participating BFD endpoints.

D. To use BFD with BGP. the timers 3 9 command must first be configured in the BGP routing process.

Answer: A

3.An engineer configured the wrong default gateway for the Cisco DNA center enterprise interface during the install.Which command must the engineer run to correct the configuration?

A. Sudi update config install

B. Sudo maglev reinstall

C. Sudo magiev-config update

D. Sudo maglev install config update

Answer: D

4.Which is statement about IPv6 inspection is true?

A. It teams and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables

B. It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables

C. It teams and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables

D. It team and secures binding for stateless autoconfiguration addresses in Layer 2 neighbor tables.

Answer: A

5.A network engineer needs to verify IP SLA operations on an interface that shows on indication of excessive traffic.Which command should the engineer use to complete this action?

A. show frequency

B. show track

C. show reachability

D. show threshold

Answer: B